Wholesale ODM China Hrmb61gd Air Cooling Welding Torch
The key to our success is “Good Solution Top quality, Reasonable Value and Efficient Service” for Wholesale ODM China Hrmb61gd Air Cooling Welding Torch, With all the everlasting goal of “continuous high quality improvement, customer satisfaction”, we are sure that our product or service excellent is secure and trustworthy and our merchandise are best-selling in the home and abroad.
The key to our success is “Good Solution Top quality, Reasonable Value and Efficient Service” for Chinajet gas torch, MIG Welding Torch, At Current, our solutions have been exported to more than sixty countries and different regions, such as Southeast Asia, America, Africa, Eastern Europe, Russia, Canada etc. We sincerely hope to establish wide contact with all potential customers both in China and the rest part of the world.
INSTRUCTIONS FOR USE:
GAS REFILLING:IMPIRTANT:Fill the appliance must be cookware or any possible source of ignition and away from other persons . 1. Before filling hceck the filling valves in firmly in place.2.Use only high quality butane gas .3 Shake the gas cartridge few times to warm the fuel .4.Turn the gas control knob to “-” (OFF) position . 5. Turn applicace upside down to expose filling valve. Hold gas cartridgeupside down and position the nozzle in filling valve. Pushdown to start releasing gas into blowtorch. 6.At the first sign of liquid gas over-flowing out of the filling valve ,stop fueling immediately . Over-fillong can cause flaring . 7.After filling allow a few minutes for gas to stablise before using the blowtorch .
IGNITION & TURNING OFF:1.Ensure that the Safte Lock is pushed uo into the unlock position . 2.Turn the Flame Adjustment Control clockwise until it is fully open .3.Turn the Gas Control Knob towards the “+” (ON) posotion until you hear the gas flow begin . 4. Press the Iginition Button . The flame will ignite instantly. 5.To turn the Blowtorch off ,turn the gas control knob to the “-” (OFF) position.
FLAME ADJUSTMENT: Adjust the flame length during operation by turning the Flame Adjustment Control . For best heating results keep the flame length between 12mm and 25mm. If the flame is too long it will waste fuel and make the flame unstable .
CAUTION
*Never turn to human body when start ignition When it’s hot ,ignition could be hard becuase gas pressure is high . Open gas control knob slightly for igniton .
When fire hole s stuffed ,it’s dangerous the fire occures from air ventilation . So please check fire hole before ignition.
Do not turn upside down the fire hole .Liquefied ags makes the ignition hard and the fire would be too big and it’s dangerous . When this occurs,colse the adjustment knob and stabilize for a moment and then re-ignite.
The key to our success is “Good Solution Top quality, Reasonable Value and Efficient Service” for Wholesale ODM China jet gas torch, With all the everlasting goal of “continuous high quality improvement, customer satisfaction”, we are sure that our product or service excellent is secure and trustworthy and our merchandise are best-selling in the home and abroad.
Wholesale ODM China jet gas torch, MIG Welding Torch, At Current, our solutions have been exported to more than sixty countries and different regions, such as Southeast Asia, America, Africa, Eastern Europe, Russia, Canada etc. We sincerely hope to establish wide contact with all potential customers both in China and the rest part of the world.